What are basement waterproofing systems and how do they work? To answer that question, let’s first look at historically conventional basement waterproofing and how it is supposed to work.

If you imagine how a basement is first built, when the house it is sited in was first conceived, then basically the following happens:

If you can see a home being built the contractor first surveys the lot using the blueprints for the home to be built; then he sights out the lot to find out the best place to start digging and grading the property, then he lays the footer or foundation and begins building the basement walls, lastly the balance of the home follows.

That big hole in the ground, the first on the list above is important to note. When the walls of the basement are built, there is always a gap left outside the walls which needs to be filled. This void gets filled with loose backfill. No matter how well the backfill is compacted, it is still backfill and water seeks the places of little resistance.

This area is going to have water constantly seeping into it. Typical basement waterproofing systems utilize water drainage pipes that often become silted. The water is naturally bringing all sorts of suspension with it. Allowing these pipes to fill up, can result in an overload of the system, which can be catastrophic to the basement’s outside walls. Water will work its way through even the smallest gaps, even though basement walls are waterproofed in some way.

This type of problem doesn’t usually go away because the pipes that are supposed to take away the excess water gradually worsen over time.

A lot of the time a huge mistake is made by not providing access to these pipes. In an attempt to keep excess moisture out basement waterproofing also can be put onto the outer walls of the basement. This is also called a tanked system.

The drained cavity basement waterproofing system is a better system that works by getting rid of water pressure in the walls. To protect the property water is controlled, collected and then made to pass through hidden drainage channels which are either natural drainage or sump pumps.

Basement waterproofing systems are superior because they are installed internaly, have easy access ports for removing silt, and can be installed in basements where other methods have failed.

So to summarise, a good basement waterproofing system will:

- usually be a permanent or long-term solution
- stop both ways by which water can enter through the walls and up from the floor
-not disturb the exterior appearance of your home
- usually be an approved waterproofing method for home loans
-more affordable than other methods

You want to be sure to choose a reliable waterproofer for your home, keep in mind that it will greatly increase the value by far more than what you initally paid.

From an expert in the field, not waterproofing can be a dumb an expensive mistake in the future.

Start using the waterproofing system for your basement with no hassle or hard work. Learn the essential steps and get a problem-free environment with minimal outlay by visiting a basement waterproofing systems website., a website describing the plus and minus points of a water proofing system.

Related posts:

  1. Basement Waterproofing - Are You Ready For The Rain? Did you know that your home is surrounded by...
  2. Right Way To Fix Leaks In Your Basement Floor There are many of us who rent a home...
  3. Easy Basement Design Basement design and basement finishing necessities are usually disregarded...
  4. Marine Global Positioning Systems For boaters and other people who navigate some water...
  5. Log Splitting and Fireplace Maintenance When it is cold outside people want to use...

Like this post? Subscribe to my RSS feed and get loads more!